Static Routing Configuration
How to configure Static Routing on pack tracer?
Router: - Router is a network device. It works on Layer-3 device which is use for routing. It takes a decision on IP address base. It connects to different- different network IP address.
Please see video to configure Static Routing on Packet Tracer.
Static routing is a manual routing where we configure the remote network using static commands.
 |
| Static routing diagram |
Router1> enable
Router1# configure terminal
Router1(config)# int gig 0/1
Router1(config-if)# ip add 10.0.0.1 255.0.0.0
Router1(config)# int gig 0/0
Router1(config-if)# ip add 20.0.0.1 255.0.0.0
Router1(config)# ip route 30.0.0.0 255.0.0.0 20.0.0.2/Gig 0/0
 |
| Static routing configuration on Router 1 |
Router2>en
Router2#config t
Router2(config)#int gig 0/0
Router2(config-if)#ip add 20.0.0.2 255.0.0.0
Router2(config-if)#no sh
Router2(config-if)#int gig 0/1
Router2(config-if)#ip add 30.0.0.1 255.0.0.0
Router2(config-if)#no sh
Router2(config-if)#exit
Router2(config)#ip route 10.0.0.0 255.0.0.0 20.0.0.1
Router2(config)#do wr
 |
| Static routing configuration on Router 2 |
0 comments
Please leave your comments...... Thanks